Farmall & IHC Tractors Discussion Board |
Re: Super C Head Stud Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Stan(VA). on September 08, 2006 at 20:50:50 from (4.248.249.30):
In Reply to: Super C Head Stud Question posted by Duane WI on September 08, 2006 at 10:00:14:
I have seen this problem on several motors also, even after re-torquing they still back off. IH switched over from studs to bolts at either the 100/200 or 130/230 tractors(looked this up before but didn't memorize it). The studs are 1/2" dia coarse thread at the block, and fine thread at the nut. You can buy the bolts at the dealer or just buy 1/2" grade 8, hex bolts (seems like either 5 or 6 inches long?) at a hardware store. After removing the studs, clean out the holes with a tap and test the bolt length in each hole to see when the bolt starts to bottom out (with head in place). My experience is that a few would need 1 or 2 flat washers to allow a proper torque w/o bottoming out (the factory ones are an odd length like 5-3/4" rather than 6" commonly available). When you find what's necessary I just use that number of washers on each for consistancy. Last thing is that the flat washers on one of the front bolts (and poss one of the back bolts?) interfere with the valve cover so you need to grind a flat on one side of those washers until they clear. Hope that helps, Stan(VA).
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|