Farmall & IHC Tractors Discussion Board |
826 Hydro with lift problem.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Centaur Nut on August 23, 2006 at 18:43:00 from (67.72.98.45):
Hye, guys, I just bought an 826 Hydro diesel thats been sitting so long that 1 rear tire had gone flat & rotted where it was creased. I was told when we bought it that none of the hydraulics, tranny, steering, lift, nothing worked so we figured the flex plate was busted like our other Hydro has done before. After getting it home we fired it up and , lo & behold the steering started working! I tried putting it in gear and after a few seconds it started moving! Then our luck ran out. The lift, which is fully raised, won't go down, even with a bush hog on it (Ever hooked up to a bush hog without dropping the lift? MAJOR fun!). You can hear some fluid noise when you move the lift lever but nothing happens. We removed the whole lift but I can't find any visible problem. There's 1 valve I can move by hand to get the lift to move so I know the piston is not stuck, but I think that valve is controlled by the draft. Any suggestions? Thanks, Rick.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|