Farmall & IHC Tractors Discussion Board |
Re: How many holes for this H hood?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron in Nebr on August 15, 2006 at 22:53:06 from (66.252.113.103):
In Reply to: How many holes for this H hood? posted by Mike CA on August 15, 2006 at 22:36:03:
Two small holes on top of the steering bump I believe were to access grease zerks on the steering support and u-joint on the steering shaft. "Thing" on the right that shows in your pic is the top of the small tank that gasoline went in to start the tractor before switching to distillate. Can't see the hole behind(in front of?) the air breather. As for holes that "need" to be there....depends. If you want it original, all the original holes need to be there in my opinion, along with the little tank that held the gas, even if you don't use it. If you want to get rid of the starting tank, fill in the holes you don't currently use, etc., then it won't be "original" it'll be a "custom". Again- it's your tractor, it's up to you.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|