Farmall & IHC Tractors Discussion Board |
needing some parts and suggestions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by banjo on July 30, 2006 at 20:31:03 from (65.67.203.126):
Finally decided to do the rebuild on my 48 super A. First, what size puller to get the crank pully off. I know it needs to be a split puller to back it, but how big? Second where do you get a oil pump rebuild kit? hopefully not at the stealership. What kit would be the best buy for the buck on sleeves, pistons,gaskets,bearings? According to the manual there are no bearings for the cam. What do you do in that area if it is worn? I do not have the sleeves out or pistons yet. but oil pressure is slim to none and constant blue smoke out the exhaust. also coolant in the oil, leaking around number 2 sleeve. number 3 sleeve and piston changed at some time in it's life. anything else to check. looked like the head had been changed at one time also. different color than the block when i bought the tractor. I have not looked at the valves but it did not miss when running.bottom of valves look good and may just need a little compound lapping. thanks.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|