Farmall & IHC Tractors Discussion Board |
Re: 5th gear on H (Photo)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on July 12, 2006 at 20:23:56 from (66.173.50.122):
In Reply to: 5th gear on H (Photo) posted by H fanatic on July 12, 2006 at 17:19:58:
As pointed out, the wear on the spline ends doesn't look horrible, however, the mating female splines may be worn more. If your tractor was jumping out of gear, I'll bet the shifter knob only moved about 1/2 inch or so between jumping out, and being as far in as it can move. If so this is an indication of worn teeth, and or a shift fork worn, or bent not inserting the splines into full engagement. If the load side wear on the splines (shown) is very flat, and not tapering off into a slight angle, and the same is true of the female splines, and the spline wear pattern is showing 3/16" of engagement, the only thing that would cause jumping out would be poor shaft alignment allowing the splines to "walk" out of engagement. Good luck, I hope this helps. We just don't have xray vision to see it when it is assembled and going down the road. What are the colored beads in the trans, wierd reflections from light? JimN
Replies:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|