Farmall & IHC Tractors Discussion Board |
Re: CLARIFICATION
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on June 05, 2006 at 06:49:00 from (66.173.50.69):
In Reply to: CLARIFICATION posted by TOM WINDSOR on June 03, 2006 at 23:09:42:
Dear Tom, The tin is cut to size and placed over the journal on the cylinder you are working on. It prevents hot metal and junk from getting on the smooth surface. The piston is going to react thermally to being melted, so I cannot say how much will be needed to be missing before it loosens up. Do not melt into the cylinder sleeve or you might incidently weld it to the cast iron of the block. Welding stripes of bead down the length of the sleeve at a reduced low penetration setting, but just enough to keep the arc going, will draw the sleeve smaller when it cools. Do not go through the thin sleeve when doing this as it will (as above) weld the sleeve to the casting. I would get to cleaning out the crud in the water jacket (under the cover mentioned) to see if the efforts I was going to make to remove the cylinder components was worth it. If the block is cracked around the cylinder castings from the effects of water freezing, or rust expansion, I would get a different block. It is fairly expensive to sleeve out a block to repair a cracked casting. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|