Farmall & IHC Tractors Discussion Board |
Re: D-300 vs D-400 engines
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on April 12, 2006 at 17:35:55 from (24.180.143.57):
In Reply to: D-300 vs D-400 engines posted by The Farmall on April 12, 2006 at 14:50:33:
Yes, a 300 series plate should bolt up to a 400 series block. 544, 656, 666, and 686 use the same bell housing. No, they are not the same as a 560. 560 has the same 12" clutch as the 706, 806, ect., while the 656 family uses somthing like a 10 1/2" clutch. 560 frame rails bolt to the front of the clutch housing while 656 family frame rails bolt to the side of the clutch housing. As for putting a 358 in a 560, start out with the flywheel, rear plate, and frame rails from a 310-powered 706, a 756 diesel, or an 826 diesel gear drive. That will get you a start. You"ll pretty much have to fabricate all the lines and linkages, when you"re done, the 358 will tear that 560 rear end to pieces.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|