Farmall & IHC Tractors Discussion Board |
Re: B434
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by FromJB2 on April 08, 2006 at 08:27:19 from (72.56.121.128):
In Reply to: B434 posted by Jack Backus on April 07, 2006 at 11:14:27:
Hi Jack, I have Operator's Manual for B414 witch is the older model. The book only describes how to set the clutch pedal adjustments and not how to adjust the dual stage clutch internally. Here is clutch pedal adjustment: 1)7 inches of free travel from floor board to rest position. Adjust by adjusting bolt on clutch arm. 2)1/2 inch free travel. Adjust by loosening bolts on clutch arm at clutch release shaft and rotating clutch release shaft. I belive if you search the archives for B414,434 or 444, someone posted the procedure to adjust the dual stage clutch through the inspect plate under the bell howsing. Good luck JB2
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|