Farmall & IHC Tractors Discussion Board |
Re: Starter ring gear for W9
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob M on April 05, 2006 at 06:15:32 from (151.190.254.108):
In Reply to: Starter ring gear for W9 posted by daballmakes on April 05, 2006 at 05:59:41:
Derrick - Give Carter & Gruenenwald a call (punch below...) They should be able to send you with a new ring gear at a reasonable cost. Often you can remove a worn ring gear, turn it around and rotate it 1/4 turn, then put it back to get more service out of it. However you still gotta go thru all the work of of splitting the tractor to do it. And for around $50 you can install a brand new ring gear - it'll be $$$ well spent. (Also install new clutch disk, pilot and throwout bearings while you have the tractor split - it will never be easier.) Another tip: Replace the starter drive (bendix) when you replace the ring gear!
Replies:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|