Farmall & IHC Tractors Discussion Board |
Re: 560 exsaust manifold
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on April 03, 2006 at 09:47:49 from (64.179.117.28):
In Reply to: 560 exsaust manifold posted by Bruce Severson on April 03, 2006 at 03:42:07:
When replacing and exhaust manifold the easiest way is to grind the exhaust manifold around the long bolts that hold it to the intake since the exhaust is junk already that way you have something to grab with a set of vice grips or 410 channel locks , and it makes it easier this way to do it then just heat around the out side on the intake and work the bolts out , while you have it apart now is the time to check the heat riser butter fly and to clean all the carbon and lead deposits out around the intake this helps with the carb iceing and faster warm up and cold stumbel. when you put the new manifold on do not tighten it down till you have it bolted up to the head then that is when you tighten the top four bolts this helps align then together .
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|