Farmall & IHC Tractors Discussion Board |
Re: rod bearing f20
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Canetractor on March 23, 2006 at 08:05:04 from (216.78.63.65):
In Reply to: rod bearing f20 posted by Joe De Keyrel on March 22, 2006 at 12:51:02:
This was not meant to be a Hi-Tech operation. The Farmall (Regular) Tractor Operators Manual gives .003--.005 as acceptable clerance. With a predetermined equal amount of shims on each side remove pairs (one from each side) until rod locks on crank. Add one to each side and this should give aprox .003. Never add or remove just one shim. John Deere manuals also give this precedure.
Replies:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|