Farmall & IHC Tractors Discussion Board |
Re: !aGary-1066 Aux. Control valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ted in NE on February 06, 2006 at 07:31:50 from (63.172.253.15):
In Reply to: !aGary-1066 Aux. Control valve posted by Michael Sheik on February 06, 2006 at 04:48:12:
If you correctly installed the back up washer then the oring for the detent piston. Oil the oring & pin. Put the detent piston carefully through the oring & back up washer, then useing a 1 fourth in roll pin for a driver install the retainer. might need to grind down the end of the roll pin slightly. Just install the retainer flush. Most common mistake to cause a leak is putting the oring for the back end of the spool over the stepped end of the spacer.It goes on the spool. Don't weld the hole shut in the hex cap, pressure from the leak will push the valve spool aherd & put it on demand
Replies:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|