Farmall & IHC Tractors Discussion Board |
Re: What size mower can a B Farmall handle?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NDS on December 24, 2005 at 11:40:49 from (64.12.117.13):
In Reply to: What size mower can a B Farmall handle? posted by TKN on December 24, 2005 at 11:12:55:
I pullled 5 foot with A (same engine as B) for years but 4 foot would have been better match. Mower worked fine but stopping to raise or lower cutting height is inconvenient. It depends on part of country you are in I live in South where grass grows fast and thick. The used small pull behinds are hard to find around here and a good one will bring 4 to 5 hundred. Small used 3 points are everywhere and a little cheaper. 90% of the 12 foot plus cutters are pull behinds around here though.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|