Farmall & IHC Tractors Discussion Board |
Cub Oil Pressure too high?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by awander on September 26, 2005 at 06:26:01 from (205.158.180.74):
My '52 Cub oil pressure gauge is consistently pegged as high as it can go. It's been this way since I bought it. While changing the oil for the first time about 2 weeks after I bought the tractor, I drained the used oil, flushed out the filter housing aand oil pan with kerosene, took out the relief valva and spring and cleeaned them, then reinstalled the drain pan plug, the relief valve and spring, the filter housing drain pipe cap, and filled the crankcase with clean kerosene. i started her up and ran her for about 5 minutes with the kerosens, during which time the pressure was indicating at about 1/4 on the gauge. Then I drained the kerosene, filled it up with clean 10W-30 oil and a new filter, and started her up again-the gauge is still pegged. I noticed when I had the pressure relief valve and spring out, that the sides of the spring had a couple of very shiny areas where it had obviously been rubbing, and also that the spring was slightly bent. What should I suspect as the culprit here? The valve? the spring?, The gauge? And am I doing any harm by running her with the pressure pegged at the top of the gauge? Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|