Farmall & IHC Tractors Discussion Board |
MUFFLER
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MITCHP on August 08, 2005 at 12:05:32 from (207.230.140.240):
I REPLACED THE MUFFLER ON MY 66 FARMALL 140 WITH A SHORTER ONE SO I COULD GET IT IN THE BASEMENT. THE NEW MUFFLER CAME FROM TRACTOR SUPPLY BUT THE INLET WAS TOO SMALL, SO I TOOK IT TO A MUFFLER SHOP AND HAD THEM TO EXPAND THE INLET WHICH WORKED, PROBLEM IS NOW I HAVE AIR LEAKING AROUND WHEN THE MUFFLER WENT OVER THE EXAUST. AFTER AWHILE ITS GONNA TURN PART OF MY HOOD BLACK. I NOTICED I HAD A PROBLEM WHEN I PUT A RAIN CAP ON IT AND IT DIDN'T WANT TO MOVE UP VERY MUCH UNLESS IT WAS AT FULL THROTTLE. CAN I GET A CLAMP THAT IS A FEW INCHES WIDE I CAN CLAMP ON THE MUFFLER TO ENSURE NO LEAKS? ANYBODY HAVE ANY SUGGESTIONS ON WHAT TO DO? COULD I CUT OFF PART OF THE EXUAST BELOW HOOD LEVEL AND PUT THE MUFFLER BACK ON?
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|