Farmall & IHC Tractors Discussion Board |
Re: C block blues
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on July 16, 2005 at 07:40:52 from (68.225.113.254):
In Reply to: Re: C block blues posted by El Toro on July 16, 2005 at 07:02:51:
Well, I thought the post was about mains, but it clearly says rod caps so in that case those rods with swapped out caps should be re-sized at a machine shop because in the case of rods you should not swap caps and if you do they should be checked for size and re-sized if needed. These old engines are not so different than modern engines in terms of clearances and basic construction and workings of the bottom end. The blocks will have been line bored/honed because there is no other way to manufacture them if you think about it and expect the crank to turn after you tighten the caps. The point of my post is to at least be aware and if you choose to ignore don't be surprised if you run up against heap big trouble.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|