Farmall & IHC Tractors Discussion Board |
Re: SC clutch problems - Long Post
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB2 on July 03, 2005 at 19:09:43 from (69.196.154.214):
In Reply to: SC clutch problems - Long Post posted by skycarp on July 03, 2005 at 18:51:55:
Hi Skycarp, on the SC that we owned, when the gears started to grind it was time to replace the pilot bushing in the flywheel. The problem is this is only a bronze bushing and when the clutch grit gets into it, it prevents the transmission drive shaft from turning in the pilot bushing when the clutch is depressed. The transmission drive shaft should stop turning and spin in the pilot bearing when the clutch is depressed. Hopefully by fixing the clutch adjusting mechanism it will fix the grinding gears but if it dosen't then probably a sieze pilot bushing. To fix requires splitting the tractor. Good luck JB2
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|