Farmall & IHC Tractors Discussion Board |
Re: M hydraulic pump question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T.B.W. on April 19, 2005 at 14:47:20 from (216.127.159.124):
In Reply to: M hydraulic pump question posted by Chris Willy on April 19, 2005 at 12:06:12:
From 51 up the pump will fit. The top holes are diffenent, the bottom ones line up ok. I put a live pump on my M by making a clamp to hold the top of the pump in place. I used 2 3/8 X 6 eye bolts and opered the eyes. I placed the open eyes in the bolt holes of the pump and I made a bracket of iron that went in front of the oil fill and pulled it tight. Works fine and with a little paint on the eye bolts, it looks ok
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|