Farmall & IHC Tractors Discussion Board |
Re: pit falls on rebuilding super M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MagMan on March 24, 2005 at 07:14:54 from (64.12.117.13):
In Reply to: Re: pit falls on rebuilding super M posted by jnewark on March 24, 2005 at 06:34:24:
I have never used plaric guage my self I would like to get some and tryit but never have.If you can read the bearing caps that are in there now and get new ones that are the same maybe even carefully mike them up to make sure if the pistons and sleeves come matched in a kit I would not worry to much unless something does not seem to fit right or turn or slide good.They say to check the sleeves after they are installed for high spots also . I guess it depends on what tools you have and time for what you do when you put it back together. You know the rods only go one way and the caps stamped with the # of the cyl goes toward the cam side of the motor I beleve.One of these mechanics should be able to chime in on anything I have wrong or missed I have not done one my self in a few years getting ready to soon as the dough heaps up. LOL MagMan
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|