Farmall & IHC Tractors Discussion Board |
Re: H, Engine RPM under load low
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RustyFarmall on March 19, 2005 at 08:53:28 from (199.120.81.212):
In Reply to: H, Engine RPM under load low posted by 230,H,M on March 19, 2005 at 05:01:34:
I guess I am somewhat confused here, any dyno I have ever been around would kill an engine if you cranked it down enough. The proper procedure for using a dyno is to open the throttle on the tractor, and then start cranking the wheel on the dyno until you are reading 540 pto rpms. At that point you take a horsepower reading. The actual speed of the tractor engine is irrelevant. You only have a problem if the observed horsepower at 540 rpm is lower than expected. Does this help? Am I totally off base?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|