Farmall & IHC Tractors Discussion Board |
F200 front wheel bearing seal questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RT (seTX) on March 07, 2005 at 10:31:52 from (139.169.220.212):
The oil seals that came with my front wheel bearing kits (not from IH) for my 200 are not like the original parts. I know is this is not unusual, but the new seal fits onto the dust deflector, instead of directly onto the axle shaft. I’m fairly sure the old seal seated onto the axle shaft itself instead of the dust deflector. There is also no room for the felt washer with the new oil seal. The new oil seal fits so tight into the wear ring that the oil seal and dust deflector are turning with the wheel assembly. I think this will allow moisture into the hub and let grease out. The IH part numbers are 43463D for the oil seal and 55453D for the felt washer. Am I correct in assuming the dust deflector should remain stationary and the movement should be between the outside of the seal and the wear ring? Is there any way, other than welding, to keep the dust deflector in place? Are the original type parts available or does anyone have part numbers from another source? Thanks in advance for your help
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|