Farmall & IHC Tractors Discussion Board |
Re: Question for ChadS - Chevy recurve kit on H di
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on February 05, 2005 at 05:58:39 from (4.224.132.95):
In Reply to: Question for ChadS - Chevy recurve kit on H dist posted by Dave in CT on February 04, 2005 at 22:37:54:
Dave, Use them as they are. They are a bit shorter, dont alter the hook loops, they will stretch far enough to reach the pins. The will hold it in the relaxed position until centrifugal force causes movement. Usually, the advance is needed when the engine accelerates, to aide acceleration, start the flame front in the cyl a bit early, reduces the possibilty of the engine preigniting and causing a backfire. 9 out of 10 Delco, and IH distributors that come in the repair shop, they advance mechanisms are failing, from years of service (worn) or dirty and rusty they will stick, or the springs will break. To test the advance, remove the distributor cap, grab the rotor, and gently twist the rotor and let go kinda quick, see if the rotor will snap back all the way back to the relaxed position, if it stops midway, you should have a closer look. ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|