Farmall & IHC Tractors Discussion Board |
Re: help with 12 volt conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jeff smith on January 04, 2005 at 16:25:34 from (198.89.66.135):
In Reply to: Re: help with 12 volt conversion posted by farmallhal on January 04, 2005 at 13:16:41:
I had the #2 pin back to the battery terminal just like the diagram. The #1 runs to the ignition. The hot wire is to the + on the coil and (-) to the dist. Could my ammeter be bad? The glass is cracked a little. I really did follow the diagram you speak of and it was not charging. I can switch out the light for the resistor. An article I read said the light would go out when it was charging so I liked that idea, I certainly can switch that out. I get the pins mixed up when talking about them but I had the diagram outside with me and double checked everything. I think I am going to have to pull out the ignition and wire it again or replace it. Is there a way to test the ammeter and find out if it is working. I would think it was since the tractor starts
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|