Farmall & IHC Tractors Discussion Board |
Re: timing fule injection pump IH 656
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aces on December 05, 2004 at 13:51:00 from (65.54.97.142):
In Reply to: timing fule injection pump IH 656 posted by John in Tx on December 05, 2004 at 09:55:20:
John You will have to get the degree of timeing from a manual. But on the outside of the pump is a plate with 2 screws the plate is about 1/2" x 1-1/4" take it of and you will 2 disks the one to the back should have a black line and it does not turn the front one does turn so you may not see it at first. If not turn the engine over til toy see the front come into the opening when it goes into the opening you are coming up to #1 compression go to the belt pulley on front of engine and set degree of time to the pointer then check the 2 lines on the pump they should line up if not loosen the 2 nuts that hold the pump on and rotate to line up lines in pump if in line that is it. Shut fuel of first because it will run out. That is about it.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|