Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Workin on the 300 some more
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tractor dan on July 05, 2004 at 13:20:03 from (64.12.117.22):
In Reply to: Re: Re: Workin on the 300 some more posted by Kelly C on July 05, 2004 at 12:54:18:
i have made two so far one for a ford 8n and the last one i made was this spring for a ford 8600 this one was a little easier because i allready had the new liners i have not yet pulled liners on a wet sleeve engine only dry i would think wet sleeve would be much easier had to make puller a bit heavier for the 8600 than 8n one its takes a lot of time to make the way i did but used tools handy to me torch, grinder, then file drilled and taped center with 3/4 inch well good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|