Farmall & IHC Tractors Discussion Board |
Re: Re: Re: international 504 pto engagement
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 09, 2004 at 17:05:56 from (64.228.11.85):
In Reply to: Re: Re: international 504 pto engagement posted by steve on June 09, 2004 at 07:18:54:
Steve: Actually I had two tractors with that pto at one time in my farming days. Mine were both Farmalls 504 and a 560. You say International so I gather yours is a Utility. My 504 had 13.6x38 and 560 had 16,9x38. I'm not just sure what the Utility tractors had, probably 28" wheel and wider than the Farmall. That pto also has an internal adjustment for the pto clutch pack. I will not try to describe that, you best go to the manual for that. The clutch pack adjustment should be checked probably every year. Manual will probably give it to you in hours on tracror meter. Another item to watch closely if your tractor is so equiped is TA and clutch adjustment. Again manual is way to go. I would only confuse you, too much room for error in use of terminology.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|