Farmall & IHC Tractors Discussion Board |
560 TA ? need advise
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by joe on April 10, 2004 at 16:26:00 from (205.146.39.78):
The Torque Amplifier only works in low range (lever back). I checked all the adjustments and removed the cover on top of the T A clutch to observe the clutch engagement. It engages just fine, there is space between the fingers and the throw-out bearing, but the clutch slips, so I have no direct drive. I just had the tractor split and thought the clutch and pressure plate was OK, but it doesn't seem to apply much force to the clutch disk. And yes, I did remove the 3- 5/16-18 cap screws when I had the clutch and pressure plate off. I suppose I will have to split the tractor again, but I don't want to take the center clutch housing off. When I had it apart before the torque amplifier assembly would only turn in one direction. I thought it was because of the rollers running up on the ramp, or am I wrong? Is there anything I can check without completely removing the TA? The tractor runs fine other than no direct drive. Any advise would be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|