Farmall & IHC Tractors Discussion Board |
Re: After Market Parts -- Need a little HELP
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jonathan Mirgon on March 27, 2004 at 19:53:26 from (205.208.129.104):
In Reply to: After Market Parts -- Need a little HELP posted by BIG JOHN on March 27, 2004 at 17:25:58:
I too have had the same problems, Battery box for my (A) was far from a bolt on, All holes were off so far that they had to be drilled out 3/8 of in inch bigger. P.t.o shield did not fit either, those holes had to be drilled out nearly a half inch bigger ! just leaving enough metal left to hold it on. Hood for the (a) has a bulge in it at the gas tank, it sticks out about 1/8 of in inch more than it should, It looks like the sheet metal they cut was to big. All of the above parts came from O.E.M. I guess I would still rather run a drill, then get rusted up used parts and glob bondo on/ and run a piece of sand paper for hours on end.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|