Farmall & IHC Tractors Discussion Board |
Re: Flywheel for a Super C
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on March 17, 2004 at 04:14:50 from (208.59.157.172):
In Reply to: Flywheel for a Super C posted by Marc in Iowa on March 16, 2004 at 14:44:21:
Marc, There are quite a few differences in the C and Super C, enough that it is not practical to try and convert one to the other (look in the archives here or study a parts book). But if you mean he is installing an overbore piston kit, fine. On the flywheel assy, it is made up of two pieces, the flywheel and a ring gear. If the flywheel has small cracks under the clutch area, it can usually be resurfaced at a machine shop; if the problem is the starter motor had been grinding away at the teeth on the ring gear, then yes just the ring can be replaced to solve that (some even just flip the ring gear over and rotate it a little to get good teeth facing the starter again.). Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|