Farmall & IHC Tractors Discussion Board |
Re: H is at it again!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chads on March 10, 2004 at 08:46:22 from (12.202.240.238):
In Reply to: H is at it again!!! posted by 49 Cubber! on March 09, 2004 at 15:10:44:
I agree with river bend. Check that brass bushing in the throttle shaft. it has 2 holes in it for vacuum passeges in the castng of the carb, and are directly for the idle circuit. the bushing, may have slipped in the bore and blocked the passeges. if that happens, it will run off of the main jet circuit and run rich. Here is a way to test it. idle it down, and lean out the carb with the main jet adjustment. if it smooths out, it is the bushing, or the carb is plugged up in the idle passages. The throttle shaft has a notch cut out in it, when it is idling, the passages are open to allow it to run on the idle side, when the rpm increases, the passages are shut down, and switched to the main load jet. in a way, the idle circuit on the H carb is an early form of a throttle position sensor. Even the idle rpm setting can mess this up too, hope this helps, ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|