Farmall & IHC Tractors Discussion Board |
Re: Compression on an H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on February 16, 2004 at 20:48:39 from (66.228.233.214):
In Reply to: Compression on an H posted by Andy in Ohio on February 16, 2004 at 19:14:28:
I have been fooled by a faulty tester on occasion; the Schrader valve core from a tire was put in the tester instead of the correct valve core from the tester manufacturer. The tire valve core had a stiffer spring and gave consistant, but low readings. Next, be sure you have all spark plugs removed, carburetor in the wide open throttle position, fully charged battery, and ignition turned off. Test all cylinders for readings on the 1st and 4th compression stroke. Now squirt motor oil in all cylinders and re-test. The readings should be a little higher(10# or so). A larger change indicates bad rings(25# or more). All cylinders should read within 10-15% of the highest reading. The "Cadillac" test proceedure is to do a cylinder leak-down test. It will pinpoint exactly where and how much each cylinder leaks. Automotive supply stores have that tester available.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|