Farmall & IHC Tractors Discussion Board |
Re: sm motor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scotc on January 29, 2004 at 20:34:33 from (162.39.3.57):
In Reply to: sm motor posted by aaron on January 27, 2004 at 20:44:31:
get onto piston manufacturers websites, there are several that will custom-build them, con rods too. try not to get the cylinder walls too thin if you dont use sleeves. Deck plate wouldn't hurt if you could find one, if money is no problem someone makes them using head gaskets as a pattern. Simulates stresses from torquing down the head so the bore is true when the heads are on, worth a couple horses. dont think its neccesary if you use sleeves though. Could go with a DT360 or a 414 in there if you aren't pulling farm stock.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|