Farmall & IHC Tractors Discussion Board |
Re: carburator adjustment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on December 24, 2003 at 19:00:14 from (66.228.96.130):
In Reply to: carburator adjustment posted by terry on December 24, 2003 at 15:17:42:
Carb adjustments are kinda easy and kinda difficult, First,, start by adjusting the idle adjustment,, Warm up the engine, and idle it down as low as it will go, adjust the idle adjustment until the smoothest operation is achieved. should not lope of smoke at an idle. then,, open the throttle to the wide open position,, start by turning the load adjustment about 1.5 turns off the seat,, and then back it out until it will smoke,, then turn the adjustment screw in until it smooths out. and no smoke,, idle the engine back down and quickly open it back up,, should operate smoothly,, the float could be still not right,, could be overflowing the fuel bowl and coming out the metering stem,, make sure that the bowl bolts are tight, a vaccum leak could happen around the venturi, and will draw fuel up past the gasket and into the venturi, Hope this helps,, ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|