Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall H swinging drawbar strap or rolle
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by williamf on December 23, 2003 at 09:11:57 from (66.82.9.18):
In Reply to: Re: Farmall H swinging drawbar strap or roller an posted by Hugh MacKay on December 22, 2003 at 18:26:22:
A prev. owner of my H had had the u bend in the middle. It was worn a little thinner right where the swinging drawbar rode. He got a salvage bar and cut it off just past the corners, right before where the angled braces attached. Then he welded it to the bottom of the u-bar so that the holes line up. You have to do sort of a double take to see what it is, that it's not just a bar as thick as it should have been from the start. Since I use Mr. Haney mostly for pulling a trailer, often a somewhat over loaded dump trailer, I took the roller off the swinging drawbar and made a strap to hang it by, also welded half inch bar stock to the bottom to help carry the weight, and to keep it from bending while backing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|