Farmall & IHC Tractors Discussion Board |
Re: Sealing The Engine Pan
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TimV on October 03, 2003 at 16:10:40 from (24.59.16.101):
In Reply to: Sealing The Engine Pan posted by Bud on October 03, 2003 at 09:41:58:
Bud: One thing to recognize with gaskets--most are designed to seal without additional sealants, and adding them can disrupt the mechanics of the sealed joint. While this is not as much a factor on older equipment, which tends to be of pretty robust construction, it still can be an issue. If you choose to use a sealant, be particularly careful not to overdo it--more is NOT better when it comes to gasket sealants! A THIN, EVEN film of a permatex-type sealant on both sides of the gasket may help in sealing the joint, but if you use too much you run the risk of causing more problems than you're solving. Too much sealant can leak into the pan and gunk up the engine. It can also cause "high spots" in the gasket, which serve as leak paths. The best way to create a leak-free joint is careful surface preparation followed by proper torque (and re-torque if necessary) procedures.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|