Farmall & IHC Tractors Discussion Board |
Farmall 140 valve settings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on May 19, 2003 at 10:04:32 from (216.208.58.138):
I have been doing mainly mechanical work on a 140 that had been parked in a heated warehouse for a number of years. After running it a few times during repairs I noticed there was some compression escape through valves. Tractor also didn't have much torque at low rpm. At beginning I found with tractor warmed up valve settings were around .012. I adjusted to .014 as the manual calls for, somewhat better but still the puffing and flutter in exhaust. I checked further into the IT manual which also covers the C-135 engine in the 404. The 404 calls for .014 on intake and .020 on exhaust valves. I proceeded to adjust the exhaust valves to see if I could take the flutter out. At .018 on the exhaust valves she purrs like a kitten. No more puffing or flutter. Am I headed for some valve work? Will it be OK to work tractor that way? Any opinions from some of you engine guys on this.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|