Farmall & IHC Tractors Discussion Board |
'H', Differential Seal, and Drive Gear Questions.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred KS on May 13, 2003 at 16:29:20 from (64.39.205.106):
Pulled my brake cover and found the shaft oil seal leaking. Removed the seal and found that my roller bearing was about to start spitting out ball bearings. Decided to go ahead and replace both differential shaft ball bearings on both sides, which brings me to these two questions. Since I'm going to pull the bearing cages, would it be easier to remove the oil seal once the cage was out? I'm thinking I could drive the seal out once the cage was removed. Also, is the bolt holding the right hand drive gear a right or left hand thread? I know the bolt on the left drive gear is right hand thread, but the parts catalog shows two part numbers for the bolt with no referrence why. Thanks, Fred KS
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|