Farmall & IHC Tractors Discussion Board |
Upper Bolster Revisited
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on January 12, 2003 at 17:28:57 from (63.171.43.140):
For those who wanted me to quit playing with my Baler and get back to work on my H. Well your wish is my command. I had to get back into the upper bolster. I still had quite a bit of play in it after the first go around. I noticed some thing different wile I took it apart this time. The pivot shaft left a indent in the bottom side of the cover at the top of the bolster. I think it is ridding higher than before. Could I posssably need a spacer between the pivot shaft and the thrust bearing? If so where do I get one of those? I had to hack saw the upper bushing out. Tapping on it did no good. If you are interested in seeing my documentation of this just click on the link and scroll down to the bottom of my web page and click on the link.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|