Farmall & IHC Tractors Discussion Board |
Flooding problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff S on August 17, 2002 at 18:33:06 from (209.176.194.186):
I have a 1946 H with a D-10 Carburator. I did a complete rebuild of the carb a few months ago using an IH rebuild kit. Now all of a sudden it it started flooding out. I have had the carb off about 4 times now (cleaning it each time), the needle and seat are clean and functioning properly, the float and axle (which were just replaced) are free and not filling up with gas, and the float is set at 1 27/32 (1.844) off of the gasket when the carb is split (measuring off of the upper half with it inverted upside down) as specified in the IH instructions. Yet, with it all re-assembled I'll hear gas dripping out of the drip hole to the garage floor on the first attempt to start it. It seems to immediately flood out. What else can I do to make this thing run?!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|