Farmall & IHC Tractors Discussion Board |
H rebuild questions?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jmyt_47 on July 31, 2002 at 10:51:17 from (170.92.1.104):
I'm rebuilding a '46 H that has sat in a barn for 10 years with it's engine apart. The block and head were cracked, so I patched the block and got a used head. The sleeves in the block looked good except the clearance between the piston and sleeve on the #4 cylinder was .010". Is this too sloppy? Should I replace the sleeve & piston? This tractor will see light duty work. The tractor also has an overbore kit in it, with the firecrater (stepped head) pistons. The used cylinder head I picked up was from a '44 H, and the combustion chamber is deeper than the one off the '46( appears to be 1/2" or so. Both heads are the same overall height. What are the differences in these heads? Valve stem lengths? rocker arm height? pushrods? Can I make it work with my block?
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|