Farmall & IHC Tractors Discussion Board |
Re: '48 M with bad clutch control yoke
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on June 07, 2002 at 11:29:17 from (166.72.245.94):
In Reply to: '48 M with bad clutch control yoke posted by Michael on June 07, 2002 at 10:41:25:
Not necessary to split the tractor to work on the M clutch. However, it's a dirty, sweaty, messy job down under that tractor. You have to take out the lift all. You likely can have your clutch rebuilt and save the cost of new stuff. Probably a clutch shop near you that can do the job. THat's what I did with my MD. The shop refaced the clutch disk, dressed up the pressure plate and put in new springs and supplied a new throw out bearing. While you are at it you will want to check the pilot bearing too. I don't think it's possible to get the flywheel out though without splitting the tractor. Search the archives, I've given instructions before on how to get the M clutch out without splitting.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|