Farmall & IHC Tractors Discussion Board |
c123 crank pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TerryC (MO) on February 15, 2002 at 16:20:51 from (208.16.108.159):
Couple of questions. After a good bit of coaxing, I got the crank pully off. I noticed there is a sleeve that fits inside the neck of the pully. This sleeve is keyed to match the crank shaft, that is obvious. However, how is the sleeve supposed to be oriented in the pully in order to keep the timing marks where they belong? There is a raised area, about the width of a key on the outside of the neck of the pully. Is this raised area supposed to align with the key notch in the sleeve? reason that I am wondering, is, that when I removed the thing, the notch in the sleeve was not aligned with this raised area, and the service book does not mention much except that this sleeve is replaced when the pully is removed. Other question is this...what is the thickness of the clutch plate supposed to be to where it needs to be replaced? thanks for the info. terryc
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|