Farmall & IHC Tractors Discussion Board |
Re: Switching negative ground back to positive
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob M on June 18, 2007 at 06:54:00 from (151.190.254.108):
In Reply to: Switching negative ground back to positive posted by BDM on June 17, 2007 at 20:51:41:
Like Gene says you can repolarize back to + ground IF the regulator is not marked "negative ground only", or such. However from a practical standpoint, why change to + ground? Running + ground greatly increases the chances of an error and damage to your tractor (also damage to the jumping vehicle) should the tractor ever need to be jump started. Also there's no performance benefit from positive ground other than it's "how it came from the factory". And your SM has already been converted from 6 to 12 volts the originality argument is pretty much moot anyway...
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|