Farmall & IHC Tractors Discussion Board |
Re: CNKS Can you help with axle seal replacement o
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J.J. from Afton on May 24, 2007 at 11:19:04 from (71.215.250.5):
In Reply to: Re: CNKS Can you help with axle seal replacement o posted by georgeky on May 24, 2007 at 11:01:46:
Ya its doable without pulling the top cover, and just pulling the PTO. We did it last year up at school on a couple Hs and Ms. Its less work overall but it is a bit more challengeing. It helps alot to have 3 or 4 pieces of threaded rod that are the same size of the bolts that hold the axle housing. Than when you go to put it back on you can thread those in and slide the axle housing in on them so its not flopping around. Than once it is lined up with the bull gear you can use some nuts to pull the axle in close enough that the axle bolts can start.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|