Farmall & IHC Tractors Discussion Board |
Re: Concurrences
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on May 09, 2007 at 06:21:41 from (199.17.6.122):
In Reply to: Re: Concurrences posted by steve laaveg on May 08, 2007 at 14:15:09:
I'm glad you did as I suggested. Even if the threads are looking bad, the pipe tap will still probably be a good choice. Tool stores sell them, but they are pricy (ergo the rental) finding a l=commercial plummer is also an option of choice (friendly is best, or it could cost more than the tap) get it aligned perfectly with the old threads and keep it lubricated with ATF. Turn in 1/8th turn, back off turn in a bit more, back off till the cutting edges clear the cut behind go slow, it is a one time thing and will be fine if approached with tenderness. Replacement manifolds are available (try to get a unit cast in the US. If threading will not work at all, and a new manifold is beyond reason, buy a ---schedule 80--- black Iron 2" NPT coupling and weld it to the top of the manifold with Nickel Rod. JimN
Replies:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|