Farmall & IHC Tractors Discussion Board |
Darwin Award
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by GordoSD on April 17, 2007 at 16:31:52 from (66.115.200.140):
Yesterday I set all the tappet gaps on the SMTA. Fired right up to warm the engine. Used a pipe wrench to turn the crank for getting pistons to TDC. Also spun it and did compression ceheck, 115 all cylinders.Painted the cover while it was off.Let cover dry overnight. This morning I installed perfect new looking cover. Checked all the wires, fuel and cranked it. Moved about a 1/4 turn anstopped. Three four tries, ditto. So out comes the charger. Four hours later I tried to start it again, this time standing by the starter. Same result but I could see the fan blade jam to a halt. Not good. I wonder did I take out the rod I was using for a gauge? SOmething is jamming the engine.Rod found. OK where's that pipe wrench I used. I'll try turning it by hand.Looked all over for it. You guessed it. There it was on the crank pulley. Removed wrench, removed battery charger, removed my head from my a_ _. SMTA fired on first revolution.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|