Farmall & IHC Tractors Discussion Board |
M Experts: Clutch inspection ports?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on March 18, 2007 at 09:14:46 from (207.170.88.80):
Please see the thread below, "Clutch Not Disengaging." The owner is getting advised to remove the starter and spray brake fluid on the clutch through the opening. While I know this is a common procedure on 8Ns and other tractors where the most frequent cause of clutch failure is leaking transmission seals, this would be the wrong thing to do on a tractor like the Farmall C where there are clutch inspection ports. If the M has a lubricated throw-out bearing like the C, he needs someone who is familiar with Ms to tell him how to check the throw-out bearing before he starts taking the starter off...
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|