Farmall & IHC Tractors Discussion Board |
Re: injector pump timing UD-16 power unit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ted in NE on March 14, 2007 at 07:53:20 from (65.39.111.143):
In Reply to: Re: injector pump timing UD-16 power unit posted by Martin Caldwell on March 14, 2007 at 04:54:29:
Look at the hub on the injection pump.It has a line on it, line up the top of the pointer that that the 3 bolts go into the drive gear with the line on the hub. The gear has a center zero mark and advance & retard marks either side of the zero mark. Install the pump set pointer at O degre mark. If you have not done anything to the timeing gears you will be on TDC #1. You can line up the mark on the crank pully if you want to but you will already be on no 1 cyl anyway. The service manual says to start the engine, run up to operating temp. Retard the timeing one mark at a time untill you get white puffs of smoke at high idle. Advance one mark at a time untill it is clean at high idle. Usually end up at TDC or slightly on advance side.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|