Farmall & IHC Tractors Discussion Board |
'46 M Farmall Leaking Hydraulic and Engine Oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tis on February 12, 2001 at 08:36:37 from (208.235.169.34):
Have a '46 M Farmall that is leaking hydraulic fluid and possibily engine oil on the underside between engine and transmission. Some seals, but not all, were replaced on the hydraulic pump; this has decreased the hydraulic leak. Also, the seal/gasket was replaced on the engine crankshaft; not sure if engine oil is still leaking, because it takes a quart of oil subsequent to pulling a disc harrow 4 to 5 hours. Question is, where can "all" the replacement seals for the hydraulic pump and possibily other engine seals be found; or, what should be done to correct these leaks. NEED HELP BADDD!! THANKS
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|