Not completely clear on your plans, but playhouse needs to be high enough for an adult to stand up in it. Floor supports need to be standard 16 inches on center apart. 1/2 inch plywood is not really thick enough. 5/8 would do, 3/4 best. 2 x 4 floor joists on edge will be ok for that width. To support floor joists, run a 4 x 4 between the 4 x 4 posts, attached by galvanized lag bolts or nails put in at an angle, reason for galvanized bolts is that the treated lumber will rust uncoated nails, in fact use ganvanized nails every where you nail into treated lumber. You can drop the floor joists down on the 4 x 4 enough to make the 4 x 4 level with the flooring.
Reason for putting 4 x 4s between posts is to have a flat surface to fasten outside siding to at the bottom. 2 x 4s edgewise up the wall to fasten siding to higher. I'm not clear if you intended siding, if not ignore this paragraph.
The playhouse I built was 8 x 8 with a 4 foot porch.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
